Double Screw and Screw Housing Measurement Chart
Double Screw Wear Check Sheet
Below is the procedure to check the wear of you double screw and housing in your Vemag or H&S model AC stuffers.
-
Step 1:
Make sure screw & housing are clean.
-
Step 2:
Place screw & housing on level surface or slide into machine.
-
Step 3:
Push the housing all the way in until it stops then pull back out 2 inches.
-
Step 4:
Slide screw in housing until 2 inches are sticking out of housing.
-
Step 5:
Rotate screws until there is material at the 12 o'lock position, push the screws in until they are flush with the front of housing.
-
Step 6:
Using a standard set of feeler gauges check the gap at the 12 o clock position.
-
Step 7:
Repeat for opposite side, record measurements.
We consider the screw and housing worn out when .016 -.020 inches of gap are obtained, depending on product. If you have any questions, please give us a call at 800-752-7507.